Here is an article based on the information you provided:

Ethereum Lighthouse is synced but no consensus updates: what’s going on?

As a user of the Ethereum blockchain and related tools like Geth (formerly Ethereum Go) and Lighthouse, I recently noticed that my setup is working properly. However, even though I am fully synced with the Beacon Network, I am not receiving new consensus updates.

To understand what could be going on, let’s break down the components involved in this scenario:

• Geth: Geth is a lightweight Ethereum node that allows users to run the full Ethereum protocol on their local machines. It is a popular choice among developers and testnets.

• Lighthouse: Lighthouse is a decentralized network of nodes that act as relay stations for Ethereum blockchains, allowing them to be mined by anyone with an Ethereum wallet. The Beacon chain is one such relay.

When the Beacon client says it is online but no consensus updates are being received:

• Beacon Network: The Beacon Network is a test network designed to validate and propagate new blocks to the main network. It uses Lighthouse nodes as relay stations.

• Geth Sync: Geth is fully synchronized with the Beacon Network, indicating that all data for a local node is updated and synchronized with the Beacon Chain.

Possible Causes:

• Lighthouse Node Issues: Although Lighthouse is a decentralized network of nodes, there may be connectivity or configuration issues with individual nodes.

• Beacon Network Connection

  : The connection between Geth and the Beacon Network may be interrupted for various reasons, such as a faulty relay station or incorrect node configurations.

• Synchronization Timeout: Depending on network congestion, synchronization timeouts may occur. This can cause a delay in updating the local node with new data.

Troubleshooting Steps:

• Check Beacon Node Status: Make sure the Beacon node is up and running by checking its status using tools like etherscan.

• Check Network Congestion

  

  : Monitor network congestion levels to identify potential issues.

• Geth Configuration: Check Geth settings such as connection timeout and sync timeout values.

Conclusion:

While it may seem counterintuitive that a fully synchronized Beacon node is not receiving new consensus updates, there may be underlying issues with the Lighthouse nodes or the Beacon Network itself. By following the troubleshooting steps and checking the status of all involved components, you should be able to identify and resolve any issues that are causing this delay.

I hope this information helps! Let me know if I can be of any further assistance.